Remodel Your Own Bathroom
Remodeling your bathroom is not always easy, but it is possible if you have some basic plumbing knowledge. Being able to handle this job on your own will save you a great deal of money, which is very important in today’s economy. Whether you want to install new fixtures or completely change the floor plan of the bathroom, a little bit of knowledge can take you a long way.
The first thing you will have to do is determine which type of bathroom configuration will work with the drainage system in your home. Even though your drainage might be able to handle the movement of some fixture, it is usually a good idea to put them back in the same spot. This is because you would have to cut holes in the floor to complete this job, which could cause problems with the home’s support. Therefore, using the existing drainage is your best bet, as it will prevent you from having to reinstall a number of different pipes.
Make sure that you provide access panels for this plumbing when installing new fixtures. Not having these access panels can make maintenance extremely difficult, which will end up costing you a great deal of money. You should be able to find a hidden place for your panels, as you would not want them to be overly obvious in location. In some cases, the access panel for your bathtub and shower will be in a different room, as there simply is not enough room for one in the bathroom.
Turn off your water before getting started, which is a step that many inexperienced individuals make. Once you have done this, you can begin installing your water feeds. These feeds should install into your existing system, which makes the process much easier. Remember that you must have an adequate amount of slope on your drains, or else you will run into drainage problems in the future. Also, make sure that you to not make too much of a slope, as this will force liquid through the pipes before the solids, which will surely lead to clogging.
Ensure that your water feeds have been pressurized before you install your fixtures. This is done by turning your water source back on and then allowing the pipes to fill completely. The pipes should be left in this state for a few hours before any fixtures are replaced. Once this has been completed, install your fixtures and attach them to the water feed. Be sure that you test everything out before you have finished, as some people mix up the hot and cold feeds. This is little bit of plumbing knowledge can definitely take you a long way if you decide to do some home renovations on your own.